DC power supply Mass Piece

Procedure: We started by calibrating the tape timer. We do this so that we know how long it takes for the hammer to strike down each time. We did this by starting the tape timer and pulling a sample piece of tape through it while someone timed how long it took for the tape to be pulled through. We did it three times, however, we never adjusted the voltage, as that would change the period of the timer. Afterwards, we counted the dots and found the average. The average that we found is the period of the hammer arm.

Afterwards we found the period of the hammer it was time to measure the acceleration of gravity. We constructed a support to hold the tape time in the air (like the one above). We then ran a strip of paper through the time and attached a mass to it. We made sure that there was no slack in the paper, and that it could fall uninh

3) How does the slope of your graph compare to the measured value of acceleration?

Some common words found in the essay are:
Piece Procedure, Error Analysis, Fall Objective, tape timer, Denver CO, acceleration gravity, Denver Saline, Watch DC, mass fall, 0019 =, paper strip, measure acceleration gravity, measure acceleration, / 2 *, remove slack letting, 2 *, / 0019 =, mass piece, average acceleration, ∆t =, ave ∆t =,
Approximate Word count = 719
Approximate Pages = 3 (250 words per page double spaced)