To set up a new hard drive, firstly you need to switch off the power supply and then remove the casing. If you were installing a new hard drive you would have to set the primary hard drive as the "master" and the new hard drive as a "slave". To do this you would have to change the jumpers, the jumpers are located on 3 pins, and these pins should be in-between where the power cable goes and the IDE cable goes. To do this properly you would have to refer to the hard drive's manual; it all depends on the hard drive itself.
When you checked and changed any jumpers, you can start to put the hard drive into the computer system. If the drive bay
All papers and essays are for research and reference purposes only!
Copyright 2002-2009
Direct Essays , LLC. All Rights Reserved. DMCA Webmasters make $$$$